5989
Varen er på lager.
Varen er bestilt fra leverandør og leveringsdato er bekreftet.
Varen er bestilt fra leverandør, men leveringsdato er ikke bekreftet.
Varen må bestilles fra leverandør.
Varen befinner seg på fjernlager.
Varen er bestilt fra leverandør, men leveringsdato er ikke bekreftet.
Varene bestilles fra vår leverandørs lager.
Ubekreftet - Ta kontakt med kundesenter for nærmere informasjon.

Tlf: 38 60 20 90     epost: post@gitarhuset.no   Frakt fra 29.-        Kjente merkevarer   God service

BOSTONPM250AS Boston BOSTONPM250AS ALPS small 250K audio (volume) potmeter PM-250-AS

ALPS small 250K audio (volume) potmeter

PM-250-AS

Kjøp
-+
53,-

Angrerett:
Husk at alt du kjøper over nett i Norge har 14 dagers full angrerett. 
Med andre ord, er du ikke fornøyd kan du returnere.

 

Frakt:

Vi har en fast frakt på kun 145.- pr ordre. 

Kirkenes eller Mandal, prisen er den samme !

Har du spørsmål rundt akkurat dette produktet? Ring 38 60 20 90
Eller post@gitarhuset.no 

 

Klikk her for å følge Gitarhuset på Facebook

Produktinfo
Support
small 250K audio (volume) potentiometer, 16mm., 10mm. bushing, M8x0,75 thread, made in Japan
 
Value:
Typically 250K pots are used for single coil pickups and 500K pots for humbucker pickups. The bigger the resistence value, the brighter the sound will be/ less highs will bleed off. 1MEG can be used to make humbuckers sound brighter.
 
Taper:
The taper of a pot refers to the way its resistance changes as the shaft is rotated. A linear taper pot will work in a linear way related to shaft rotation. As the human ear is not linear in response to increasing volume an audio or logarithmic pot will work best for volume applications.
 
Shaft:
A split, knurled shaft will hold most knobs. Sometimes the knob is mounted using a set screw. You should order a solid shaft pot, or align the set screw with the split for correct mounting.
 
Bushing:
The standard bushing diameter is 3/8" or 9,5mm, used in most made in USA guitars. Another industry standard is M8, as used by guitar builders outside of the USA. When space is limited mini pots are used with a shaft diameter of 7mm.
The standard bushing length is .375" for inch type pots and 10mm for metric type pots. Using two nuts it is very easy to set the correct bushing length for knob placement. Specially for pickguard (ST, PB) or control plate mount (TE, JB) the .250" short bushing will fit perfectly using only one nut.
For use with a thick or carved top (LP USA) you should order a bushing length of .750".
 
CTS is (and has been since the 50's) a factory standard for most USA brands like Fender and Gibson. Alpha is a good alternative, nowadays used as a factory standard by Ibanez, Epiphone and Squier.